To avoid possibility of
induced noise from the car's electrical system, run wires away from the
car's electrical wiring.
Not outside or underneath
Exposed wires have a chance of
being cut or damaged. It is best to run all wires through the vehicle
under the carpet and/or side panels. This lends to a cleaner
installation and less risk of damage.
Avoid sharp edges
When laying wiring inside the
car, watch for welding burs in channels throughout the car. If
necessary
adequately grind, finish sand or fill in around any ruff spots so wires
will not be punctured by sharp protrusions.
:: Basic ::
void mixing wires
Run signal wires away from
electrical wires
On the same point
When using multiple
components
all units must be grounded at the same point.
